AMPMODU 2.54mm [.100"] Centerline Interconnection System - Italian Range METRIC Catalogue 1773393 Revised 01-05 Dimensions are millimetres over inches MOD II Crimp Snap-In Receptacle Contacts, with Insulation Support Material and Finish: Phosphor bronze, plated as follows: Plating A--Pre-tin plated 0.8 m Plating B--Selectively plated 0.4 m gold on contact area, with gold flash over 1.3 m nickel on entire contact Plating C--Selectively plated 0.4 m gold on contact area, over 1.3 m nickel on entire contact Plating D--Selectively plated 0.8 m gold on contact area, with gold flash over 1.3 m nickel on entire contact Wire Size Range mm2 AWG 0.5-0.2 20-24 0.32-0.13 0.08-0.04 22-26 28-30 Insulation Diameter mm 1.60 max 0.90-1.55 0.64-1.27 Part Numbers Plating Strip Form Hand Tool Loose Piece Plating D 281999-1 - Plating A 281556-2* - Plating B 280530-1 181270-1 Plating C 280530-3 181270-3 Plating D 280530-4 181270-4 Plating A 280708-2* 182206-2* Plating B 280422-1 181271-1 Plating A 280709-2* 182207-2* - 58654-1 58654-1 * With high contact pressure Technical Documents: Product Specification 108-20025 Application Specification 114-20004 MOD II Crimp Snap-In Pin Contacts, with Insulation Support Material and Finish: Phosphor bronze, plated as follows: Plating A--2.5 m tin over 1.3m nickel on entire contact Plating B--Selectively plated 0.4 m gold on contact area, with gold flash over 1.3 m nickel on entire contact Wire Size Range mm2 AWG Insulation Diameter mm 0.32-0.13 22-26 0.90-1.55 0.08-0.04 28-30 0.64-1.27 Plating Part Numbers Strip Form Loose Piece Plating B 86557-6 86561-6 Plating A 1-86557-4 86561-9 Plating B 88048-4 - Plating A 88048-2 - Hand Tool 58535-1 - Technical Documents: Application Specification 114-16003 14 Products for Industrial & Commercial Applications Dimensions are shown for reference purposes only. Conversion Rate: 25.4mm = 1 inch Dimensions are in inches and millimetres unless otherwise specified. Values in brackets are metric equivalents. Specifications subject to change. www.tycoelectronics.com